塑料薄膜,Plastic Film

1)Plastic Film塑料薄膜

1.The Use Of Plastic Film To Prevent The Cracking Of Deep Drawing Part;用塑料薄膜解決深拉深件的破裂問題

2.Seedling Technique Covering With Plastic Film To Lalix Gmelini;興安落葉松塑料薄膜覆蓋育苗試驗初報

3.The Feasibility Of Sericulture Under Plastic Film;大蠶塑料薄膜覆蓋育可行性研究

英文短句/例句

1.Automatic Plastic Bag Film Seaming And Cutting Machine塑料薄膜袋自動封剪機

2.Plastic Film Continuous Sealing Machine塑料薄膜連續封口機

3.Stacked Plastic Film Capacitor疊片塑料薄膜電容器

4.Haversack Of Sheeting Of Sheeting Of Plastics Or Of Textile Materials背包,塑料薄膜或紡織材料制

5.Dressing Case, Of Sheeting Of Plastics Or Of Textile Materials化妝箱,塑料薄膜或紡織材料制

6.Kitbag, Of Sheeting Of Plastics Or Of Textile Materials長形用具袋,塑料薄膜或紡織材料

7.Knapsack, Of Sheeting Of Plastics Or Of Textile Materials旅行用背包,塑料薄膜或紡織材料制

8.Hatbox Of Traveling, Of Sheeting Of Plastics Or Of Textile Materials旅行用帽盒,塑料薄膜或紡織材料制

9.Gun Holster Of Leather Sheeting Of Plastics Or Textile Materials手槍套,皮革、塑料薄膜或紡織材料制

10."Remove The Plastic Wrapping, Adhesive Tape And Styrofoam From The Balance."去除塑料薄膜、膠帶和泡沫材料

11.Chest, Traveling, Of Sheeting Of Plastics Or Of Textile Materials旅行箱,塑料薄膜或紡織品制

12.Document Case, Of Sheeting Of Plastics Or Of Textuile Materials文件箱,塑料薄膜或紡織品制

13.Test Methods Of Plastic Films For Electrical PurposesGB/T13541-1992電氣用塑料薄膜試驗方法

14.Plastics-Determination Of Tensile Properties Of FilmsGB/T13022-1991塑料薄膜拉伸性能試驗方法

15.Gravure Ink For Cold-Laminating Plastic Film凹版冷復合塑料薄膜油墨

16.Gravure Ink For Hot-Laminating Plastic Film凹版熱復合塑料薄膜油墨

17.Cigarette Case Of Leather, Sheeting Of Plastics Or Textile Materials香煙盒,皮革、塑料薄膜或紡織品制

18.Eyeglass Case, Of Leather, Sheeting Of Plastics, Paperboard Or Textile Materials眼鏡盒,皮革、塑料薄膜、紙板或紡織品制

相關短句/例句

Plastics Film塑料薄膜

1.Advances Of Extrusion Equipment For Plastics Film, Including Blown Film Lines, Biaxially Oriented Film Lines, Calendered Film Lines And Various Accessories Such As Dies,Air Rings,Screenchangers,Melt Bumps, Are Introduced.介紹了近年來塑料薄膜生產設備的最新進展 ,包括擠出吹塑薄膜設備、雙向拉伸薄膜設備、流延設備以及各種輔機 ,包括機頭、風環、牽引、換網器等的技術進展。

2.When A Biaxially Oriented Plastics Film Is Breadthwise Stretched, The Distribution Of The Crystallizability Affected By The Temperature And Stress Will Be The Most Important Factor Of The Thickness Distribution.本研究主要針對的是雙向拉伸塑料薄膜橫向拉伸成型技術，包括對橫向拉伸后的應力以及相對結晶度分布的研究。

3)Plastic Membrane塑料薄膜

1.This Article Introduces A Method To Determine The Plastic Membrane Tensile Modulus By Using A Normal Mart Electron Tensile Testing Machine And Computers.文章介紹了一種利用普通的智能電子拉力試驗機配以計算機來計算塑料薄膜拉伸彈性模量的方法。

4)Plastic Films塑料薄膜

1.The Adsorption Of 11 Kinds Of Organic Solvents(Benzene,Toluene,Xylene,Etc) Used In Printing In Plastic Films Was Studied By Headspace Gas Chromatography With HP-INNOWAX(30m×0.25μm)毛細管柱的頂空氣相色譜法,對塑料薄膜印刷油墨過程中11種常用有機溶劑:苯、甲苯、二甲苯(含對二甲苯、鄰二甲苯、間二甲苯、乙苯)、乙醇、異丙醇、正丁醇、異丁醇、丙酮、丁酮、乙酸乙酯、乙酸丁酯的吸附性能進行了分析研究。

5)Plasticfilm Pouch塑料薄膜袋

6)Waste Plastics Film廢塑料薄膜

1.In Order To Solve Problems Of Traditional Ways Of Cleaning With Water For Waste Plastics Film, Adopting Ways Of Dry Cleaning (Cleaning Without Water) Is Put Forward Based On The Concept Of Cleaner Production.本文基于清潔生產的理念,針對廢塑料薄膜采用濕法清洗—水清洗方式所存在的問題,提出采用干法清洗,以節約寶貴的水資源和減少污水的排放對環境造成的污染。

延伸閱讀

塑料薄膜　　可熔或可溶的聚合物通過成型加工變成柔軟、均勻、非常薄的片層材料。厚度在0.25毫米以下（最薄的可達幾個微米）。厚度超過0.25毫米的通常稱為片材。電絕緣用塑料薄膜具有高的機械強度和一定的伸長率、高的擊穿強度和熱態絕緣電阻，并有相應的耐熱性。塑料薄膜在電工技術中的應用使絕緣材料大為改觀。例如，在電機槽絕緣中用聚酯薄膜代替黃蠟布后，提高了絕緣的耐熱性并減小了絕緣的厚度；在電力電容器中用聚丙烯薄膜部分或全部取代電容器紙,能縮小電容器的體積,提高電容器的比特性(單位體積的電容)；均苯型聚酰亞胺薄膜的出現更使絕緣結構的耐熱等級提高到 H級及以上。　　　　塑料薄膜作為電工薄膜絕緣材料需要考慮多種性能。表中歸納了供選擇薄膜用的主要特性與評價結果。　　　　有些塑料薄膜可作為低溫電工絕緣材料。例如聚四氟乙烯、聚酰亞胺，高密度拉伸聚乙烯、聚酰亞胺、聚酰胺（尼龍-11）等的薄膜,均可用作超導低溫絕緣材料。